New Features - May 2022
Open full view...Categories: New Features
Based on feedback from Metalworking Specialists, these are the changes in the next revision of MSC MillMax
We fixed a glitch where the condition indicated yellow at the highest RPM when the dial showed red.
We have added a TROCHOIDAL milling selection under SETUP. This is for high axial and low radial (10% or less) engagement applications. We have created a new algorithm for these types of tool paths.
The resulting Dashboard is limited to a 10% width of cut. Greater than 10%, use the conventional MILLING setting.
You can now, in DCC, adjust the Dashboard settings (speed, feed width and depth of cut), then press APPLY to save the settings.
This will automatically change the CURRENT CONDITIONS fields and, after publishing the Dashboard, it will now open at these settings.
We have changed the image for indexable milling tools.
You can now lock the depth of cut or width of cut so you can easily adjust the opposite with the milling tool image gage.